HEIDENHAIN TNC 320 - Page 36

Contents
36
HEIDENHAIN | TNC 320 | User’s manual for cycle programming | 9/2016
15.8 MEASURE RECTANGLE OUTSIDE (Cycle 424, DIN/ISO: G424)...................................................... 398
Cycle run............................................................................................................................................... 398
Please note while programming:..........................................................................................................398
Cycle parameters.................................................................................................................................. 399
15.9 MEASURE INSIDE WIDTH (Cycle 425, DIN/ISO: G425)................................................................... 401
Cycle run............................................................................................................................................... 401
Please note while programming:..........................................................................................................401
Cycle parameters.................................................................................................................................. 402
15.10MEASURE RIDGE WIDTH (Cycle 426, DIN/ISO: G426)....................................................................404
Cycle run............................................................................................................................................... 404
Please note while programming:..........................................................................................................404
Cycle parameters.................................................................................................................................. 405
15.11 MEASURE COORDINATE (Cycle 427, DIN/ISO: G427)......................................................................407
Cycle run............................................................................................................................................... 407
Please note while programming:..........................................................................................................407
Cycle parameters.................................................................................................................................. 408
15.12MEASURE BOLT HOLE CIRCLE (Cycle 430, DIN/ISO: G430)........................................................... 410
Cycle run............................................................................................................................................... 410
Please note while programming:..........................................................................................................410
Cycle parameters.................................................................................................................................. 411
15.13MEASURE PLANE (Cycle 431, DIN/ISO: G431)................................................................................ 413
Cycle run............................................................................................................................................... 413
Please note while programming:..........................................................................................................413
Cycle parameters.................................................................................................................................. 414
15.14Programming Examples..................................................................................................................... 416
Example: Measuring and reworking a rectangular stud....................................................................... 416
Example: Measuring a rectangular pocket and recording the results...................................................418