HEIDENHAIN TNC 320 - Page 37

HEIDENHAIN | TNC 320 | User’s manual for cycle programming | 9/2016
37
16 Touch Probe Cycles: Special Functions......................................................................................419
16.1 Fundamentals...................................................................................................................................... 420
Overview............................................................................................................................................... 420
16.2 MEASURE (Cycle 3)............................................................................................................................ 421
Cycle run............................................................................................................................................... 421
Please note while programming:..........................................................................................................421
Cycle parameters.................................................................................................................................. 422
16.3 MEASURING IN 3-D (Cycle 4)............................................................................................................423
Cycle run............................................................................................................................................... 423
Please note while programming:..........................................................................................................423
Cycle parameters.................................................................................................................................. 424
16.4 3D PROBING (Cycle 444).................................................................................................................... 425
Cycle run............................................................................................................................................... 425
Cycle parameters.................................................................................................................................. 427
Please note while programming:..........................................................................................................429
16.5 Calibrating a touch trigger probe......................................................................................................430
16.6 Displaying calibration values............................................................................................................. 431
16.7 CALIBRATE TS (Cycle 460, DIN/ISO: G460)...................................................................................... 432
16.8 CALIBRATE TS LENGTH (Cycle 461, DIN/ISO: G461)...................................................................... 436
16.9 CALIBRATE TS RADIUS INSIDE (Cycle 462, DIN/ISO: G462).......................................................... 438
16.10CALIBRATE TS RADIUS OUTSIDE (Cycle 463, DIN/ISO: G463)...................................................... 440