HEIDENHAIN TNC 320 - Page 38

Contents
38
HEIDENHAIN | TNC 320 | User’s manual for cycle programming | 9/2016
17 Touch Probe Cycles: Automatic Tool Measurement..................................................................443
17.1 Fundamentals...................................................................................................................................... 444
Overview............................................................................................................................................... 444
Differences between Cycles 31 to 33 and Cycles 481 to 483............................................................. 445
Setting machine parameters................................................................................................................. 446
Entries in the tool table TOOL.T...........................................................................................................448
17.2 Calibrate the TT (Cycle 30 or 480, DIN/ISO: G480 Option 17)........................................................450
Cycle run............................................................................................................................................... 450
Please note while programming:..........................................................................................................450
Cycle parameters.................................................................................................................................. 450
17.3 Calibrating the wireless TT 449 (Cycle 484, DIN/ISO: G484, DIN/ISO: G484)................................451
Fundamentals........................................................................................................................................ 451
Cycle run............................................................................................................................................... 451
Please note while programming:..........................................................................................................452
Cycle parameters.................................................................................................................................. 452
17.4 Measuring tool length (Cycle 31 or 481, DIN/ISO: G481)............................................................... 453
Cycle run............................................................................................................................................... 453
Please note while programming:..........................................................................................................453
Cycle parameters.................................................................................................................................. 454
17.5 Measuring tool radius (Cycle 32 or 482, DIN/ISO: G482)................................................................455
Cycle run............................................................................................................................................... 455
Please note while programming:..........................................................................................................455
Cycle parameters.................................................................................................................................. 456
17.6 Measuring tool length and radius (Cycle 33 or 483, DIN/ISO: G483).............................................457
Cycle run............................................................................................................................................... 457
Please note while programming:..........................................................................................................457
Cycle parameters.................................................................................................................................. 458