HEIDENHAIN TNC 320 - Page 462

Tables of Cycles
18.1 Overview
18
462
HEIDENHAIN | TNC 320 | User’s manual for cycle programming | 9/2016
Cycle
number
Cycle designation DEF
active
CALL
active
Page
409 Reference point at ridge center (FCL 3 function)
■
332
410 Datum from inside of rectangle
■
335
411 Datum from outside of rectangle
■
339
412 Datum from inside of circle (hole)
■
342
413 Datum from outside of circle (stud)
■
347
414 Datum from outside of corner
■
351
415 Datum from inside of corner
■
356
416 Datum from circle center
■
360
417 Datum in touch probe axis
■
363
418 Datum at center between four holes
■
365
419 Datum in any one axis
■
369
420 Workpiece—measure angle
■
384
421 Workpiece—measure hole (center and diameter of hole)
■
387
422 Workpiece—measure circle from outside (diameter of circular stud)
■
391
423 Workpiece—measure rectangle from inside
■
395
424 Workpiece—measure rectangle from outside
■
398
425 Workpiece—measure inside width (slot)
■
401
426 Workpiece—measure outside width (ridge)
■
404
427 Workpiece—measure in any selectable axis
■
407
430 Workpiece—measure bolt hole circle
■
410
431 Workpiece—measure plane
■
410
460 Calibrate the touch probe
■
432
461 Calibrate touch probe length
■
436
462 Calibrate touch probe inside radius
■
438
463 Calibrate touch probe outside radius
■
440
480 Calibrate the TT
■
450
481 Measure/Inspect the tool length
■
453
482 Measure/Inspect the tool radius
■
455
483 Measure/Inspect the tool length and the tool radius
■
457
484 Calibrate TT
■
451