25
(1) Ignition key
Location : On the left side of the rear cowl,
above rear wheel.
Operation : Insert the ignition key (1) and
turn in clockwise to unlock the seat. To
install, engage the seat hooks with frame
and press the seat until the lock clicks.
SEAT LOCK
PRE- RIDE INSPECTION
Clean your vehicle regularly. It protects the
surface finish. Avoid cleaning with products
that are not specifically designed for vehicle
surfaces.
•
Front brake-Check for correct brake fluid
level in master cylinder/reservoir (page
47).
• Rear brake (Disc type)-Check for correct
brake fluid level in the reservoir (page 48).
•
Programmed FI malfunction indicator
lamp (MIL)-When the ignition switch is
turned “ON” the programmed FI
malfunction indicator lamp (MIL) glows
continuously and then should go “OFF”
once the engine is started.
•
Engine oil level-Check and top up engine
oil if required (page 37). Check for leaks.
• ABS indicator-Check ABS indicator for
proper functioning of ABS (page 22).
Inspect your vehicle every day before you start
the engine. The items listed here will only take
a few minutes, and in the long run they can
save time, expense, and possibly your life.
Please follow the tips as given below:
•
Fuel level-Ensure sufficient fuel is available
in the fuel tank for your journey. Fuel level
segment should be above one segment
blinking (page 19). Check for leaks.
You should conduct pre ride inspection before
riding the vehicle to enhance riding comfort
and safety.
CAUTION
!!
Do not park the vehicle under direct sunlight
as it causes evaporation of petrol due to heat
and deterioration of paint gloss due to ultra
violet rays.
WARNING
!!
Petrol is extremely flammable and is explosive
under certain conditions. Refill in a well
ventilated area with the engine stopped. Do
not smoke or allow flames or sparks in the
area where the vehicle is refilled or where
petrol is stored.
1
To Next Page
Loading...
