HERO XTREME 160R PROGRAMMED FI - PARKING PROCEDURE; TOOL KIT;FIRST AID KIT

30
•
In case of ABS malfunction, the brake
system will work as conventional (Non-
ABS) brake. Rider is recommended not to
apply hard brake to prevent wheel lock and
visit Authorised Hero MotoCorp workshop.
Don't's
•
Don't panic by mechanical noises or slight
lever pulses while applying the brake
(whenever ABS actuates) in vehicle. These
conditions are normal and indicates that
ABS is working.
•
Don't apply the hard braking in wet or rainy
conditions and while taking a turn.
•
Do not adjust the wheel speed sensor air
gap yourself.
•
encoderDo not attempt to correct the teeth
by bending manually or by using any other
mode. Do not use a different encoder teeth
•
rDo not inse t any metallic part near wheel
speed sensor.
•
Don't try to service HECU or open to
separate the parts.
•
Don't use the non-genuine spares like pads,
discs, tyres etc.
CAUTION
!!
•
Park the vehicle on firm level ground to
prevent overturning.
•
While parking on side stand engage the first
gear.
The tool kit (1) is located below the seat in the
rear. Some emergency repairs, minor
adjustment and parts replacement can be
performed with the tools contained in the kit.
TOOL KIT/FIRST AID KIT
(1) Tool kit (2) First aid kit
2
1
NOTE
•
ABS may not work if the battery is discharged.
•
ABS consists of an electric motor, from
which sound can be heard.
•
ABS may get activated without brake
application while riding on uneven road
surfaces (sharp drop or rise on the road
level). This is normal functioning of ABS and
won’t be having any impact on performance.
•
ABS operation is also affected by road
conditions, vehicle handling and brake
operation. It is the rider’s responsibility to
ride at reasonable speed and to leave a
margin of safety.
PARKING
After stopping the vehicle, shift the
transmission to neutral, turn the ignition
switch “OFF” ( ), park the vehicle on main
stand, lock the steering and remove the key.
Ÿ Handle pin spanner-1 No.
Ÿ Grip-1 No.
Ÿ Tool bag-1 No.
Ÿ Box wrench P16 x 14-1 No.
Kit consists of following tool:
Ÿ + , - Driver No.2-1 No.