48
level decreases abruptly, check for the
leakages in the brake system and consult your
Authorised Hero MotoCorp workshop.
(1) Master cylinder (2) "Lower" mark
2
1
NOTE
• Clean the dirt and mud accumulation
between the front brake caliper (3), brake
pads (4) and the disc (5) by using a water jet.
Refer to the safety precautions on (page 32).
Fluid level - Ensure that the brake fluid level
does not fall below "LOWER" mark (2) on the
DoT3 or DoT-4.
Location : Near pillion footrest.
Brake fluid recommended:
reservoir parallel to the ground. The level
decreases gradually due to piston movement
to compensate pad wear. If the level decreases
abruptly, check for the leakages in the brake
system and consult your Authorised Hero
MotoCorp workshop.
(b) Rear brake (Disc type)
Reservoir (1)
(3) Brake pad (4) Caliper (5) Disc
(1) Reservoir (2) “Lower” mark
4
3
LOWER
1
• Always contact your Authorised Hero
MotoCorp workshop for refilling of master
cylinder/reservoir when necessary. Do not
mix DoT 3 and DoT 4 brake fluid.
• Always use recommended tyres (page 55)
for better braking performance.
2
5
To Next Page
Loading...
