HOTMOUSE
Hotmouse is an exclusive function offered by HETEC V-Switch quad II. It works with your standard mouse or
trackball. Similar to using hotkeys on your keyboard, Hotmouse is a quick and comfortable way to operate
V-Switch quad II simply with your standard mouse, trackball, or touch screen. No software or additional
hardware is required.
When activated, your mouse cursor becomes Hotmouse Cursor - a gray and white rectangle - that allows
performing all Hotmouse functions.
ACTIVATING Hotmouse Cursor
To activate Hotmouse Cursor move / shake your mouse at the console rapidly four times in alternating
horizontal direction.
——u t—— ——u t—— or t—— ——u t—— ——u
The Hotmouse Cursor can also be activated via touch screen: tap the screen twice, and leave your finger
pressed on the touchscreen after the second tap (tap – hold, like a double click without lifting the finger on the
second click), until the Hotmous Menu opens. Now click outside the Hotmouse Menu to open the Hotmouse
Cursor.
The Hotmouse Cursor changes its look depending on its position on the screen (arrows in vertical or horizontal
direction, and number of channel).
Use the Hotmouse Cursor to perform the following functions:
in Fullscreen mode: - Switch to another fullscreen channel
in Quad mode: - Select another active channel (keyboard, mouse)
in PiP mode: - Modify position and size of PiP images
- Change active channel
HOTMOUSE - ACTIVATING HOTMOUSE CURSOR
To Next Page
Loading...
General