HETEC V-Switch quad II - Page 60

V-Switch quad II - Installation and Operation Manual
HOTMOUSE
56
Hotmouse Cursor IN PIP MODE
Change active channel
Enable Hotmouse Cursor. Move the Hotmouse Cursor to the PiP-image of the channel you wish to activate
and press the left mouse button.
Example: Switch active channel from 2 to 3
Vertical positioning of PiP images
Activate Hotmouse Cursor. Move the Hotmouse Cursor to the PiP-image area, hold down the left mouse
button and drag the PiPs to the desired vertical position.
Example: Move PiP images upwards.
HOTMOUSE CURSOR IN PIP MODE
Note:
When the Hotmouse Cursor moves over a PiP-image, its appearance changes
(arrows, channel number).
Note:
As soon as the Hotmouse Cursor moves over a PiP image, its appearance changes
(arrows, channel number).