December 2016 Page 5-9
PLT-01668, Version: 1.2 System Overview - Troubleshooting
# 144
EEPROM Corrupt
EEPROM Read
Error
EEPROM
restored with
factory default
values.
If changes were made in the Advanced Setting tab in the printer
driver, click the Default button to reset these numbers.
Reset the printer and try again. If this problem persists, call for
technical assistance.
#202
Encoder not
installed
You are trying
to send
encoding data,
but the Printer
is not
configured
with this
Encoder type.
iCLASS, Prox,
MIFARE,
SmartCard
Ensure that no encoding data is being sent with the print job and
reprint the card.
Install an encoding module.
Error Message Cause Solution
To Next Page
Loading...
