Emergency starting engine
1. Remove the top cowling.
2. Remove the flywheel cover.
3.Prepare the engine for starting. For fur-
ther information, see page 58. Be sure the
engine is in neutral and that the clip is
attached to the engine shut-off switch.
4. Turn on the main switch.
5. Insert the knotted end of the emergency
starter rope into the notch in the flywheel
rotor and wind the rope around the fly- wheel
several turns clockwise.
6. Give a strong pull straight out to crank
the engine. Repeat if necessary. WARNING!
Do not install the top cowling when
engine is running.
Treatment of submerged motor
If the outboard motor is submerged, immedi-
ately take it to a Hidea dealer. Otherwise
some corrosion may begin almost immedi-
ately. NOTICE: Do not attempt to run the
outboard motor until it has been com-
pletely inspec.