into the dipstick guide, otherwise the oil level
measurement will be incorrect.
10. Recheck the oil level using the dipstick
to be sure the level falls between the up- per
and lower marks. Consult your Hidea dealer
if the oil level is out of
specified level.
Inspecting wiring and connectors
●
Inspect that each connector is engaged
securely.
●
Inspect that each ground lead is properly
secured.
1. Lower level mark
2. Oil dipstick
3. Upper level mark
11. Start the engine and make sure that the
low oil pressure-alert indicator remains off.
Also, make sure that there are no oil leaks.
NOTICE: If the low oil pressure- alert
indicator comes on or if there are oil leaks,
stop the engine and find the cause.
Continued operation with a problem could
cause severe engine
Checking propeller
damage. Consult your Hidea dealer if the
problem cannot be located and corrected.
12. Dispose of used oil according to local
regulations.
TIP:
●
For more information on the disposal of
used oil, consult your Hidea dealer.
●
Change the oil more often when operating
the engine under adverse conditions such as
extended trolling.
You could be seriously injured if the en-
gine accidentally starts when you are
near the propeller. Before inspecting, re-
moving, or installing the propeller, place
the shift control in neutral, turn the main
switch to “ ” (off) and remove the key,
and remove the clip from the engine shut-
off switch. Turn off the battery cut-off
switch if your boat has one.
Do not use your hand to hold the propeller
when loosening or tightening the propeller
To Next Page
Loading...
Need help?
General
