turns smoothly and that it completely re-
turns to the fully closed position.
●
Look for loose or damaged connections of
the throttle and shift cables.
Remote control models:
●
Turn the steering wheel full-right and full-
left. Make sure operation is smooth and
unrestricted throughout the whole range
with no binding or excessive free play.
●
Operate the throttle levers several times to
make sure there is no hesitation in their
travel. Operation should be smooth over the
complete range of motion, and each lever
should return completely to the idle po-
sition.
●
Look for loose or damaged connections of
the throttle and shift cables.
1. Cord
2. Clip
3. Engine shut-off switch
1. Cord
2. Clip
3. Engine shut-off switch
Engine shut-off cord (lanyard)
Inspect the engine shut-off cord and clip for
damage, such as cuts, breaks, and wear.
Engine oil
Put the outboard motor in an upright po-
sition (not tilted). NOTICE: If the motor is
not level, the oil level indicated on the
dipstick may not be accurate.
2. Remove oil dipstick and wipe it clean.
3. Insert the dipstick and remove it again.
Be sure to completely insert the dipstick
into the dipstick guide, otherwise the oil
level measurement will be incorrect.
4. Check the oil level using the dipstick to
be sure the level falls between the upper
To Next Page
Loading...
Need help?
General
