EasyManuals Logo

Hidea F40 User Manual

Hidea F40
100 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #73 background imageLoading...
Page #73 background image
67
Maintenance
Transporting and storing
outboard motor
WARNING
USE CARE when transporting fuel tank,
whether in a boat or car.
DO NOT fill fuel container to maximum
capacity. Gasoline will expand consid-
erably as it warms up and can build up
pressure in the fuel container. This can
cause fuel leakage and a potential fire
hazard.
Leaking fuel is a fire hazard. When
transporting and storing the outboard
motor, disconnect the fuel line from the
outboard motor to prevent fuel from
leaking.
Never get under the outboard motor
while it is tilted. Severe injury could occur
if the outboard motor accidentally falls.
Do not use the tilt support lever or knob
when trailering the boat. The outboard
motor could shake loose from the tilt
support and fall. If the outboard motor
cannot be trailered in the normal running
position, use an additional support device
to secure it in the tilt position.
When storing or transporting the outboard
motor, make sure to follow the procedure list-
ed below.
Disconnect the fuel line from the outboard
motor.
Tighten the fuel tank cap and its air vent
screw.
When the outboard motor is tilted pro-
longed time for mooring or trailering the boat,
disconnect the fuel line from the out- board
motor. Tighten the fuel tank cap and its air
vent screw.
The outboard motor should be transported
and stored in the normal running position. If
there is insufficient road clearance in this po-
sition, then trailer the outboard motor in the
tilt position using a motor support device
such as a transom saver bar. Consult your
Hidea dealer for further details.
Storing outboard motor
When storing your Hidea outboard motor for
prolonged periods of time (2 months or
longer), several important procedures must
be performed to prevent excessive damage.
It is advisable to have your outboard motor
serviced by an authorized Hidea dealer prior
to storage. However, you, the owner, with a
minimum of tools, can perform the following
procedures.
NOTICE
To prevent problems which can be
caused by oil entering the cylinder from

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hidea F40 and is the answer not in the manual?

Hidea F40 Specifications

General IconGeneral
BrandHidea
ModelF40
CategoryOutboard Motor
LanguageEnglish

Related product manuals