outboard motor. [ECM00713]
screw. Insert and tighten the gear oil
TIP:
For disposal of used oil, consult your
Hidea dealer.
5. Put the outboard motor in a vertical posi-
tion. Using a flexible or pressurized fill- ing
device, inject the gear oil into the gear oil
drain screw hole.
Recommended gear oil:
Hypoid gear oil SAE#90
Gear oil quantity:
F40 0.610 L
(0.645 US qt, 0.537 Imp.qt)
F60 0.610 L
(0.645 US qt, 0.537 Imp.qt)
6. Put a new gasket on the oil level plug.
When the oil begins to flow out of the oil level
plug hole, insert and tighten the oil level plug.
drain screw.
Tightening torque:
9 Nm (0.9 kgf-m, 6.6 ft-lb)
Cleaning fuel tank
Gasoline is highly flammable, and its va-
pors are flammable and explosive.
●
If you have any question about properly
doing this procedure, consult your Hidea
dealer.
●
Keep away from sparks, cigarettes,
flames, or other sources of ignition when
cleaning the fuel tank.
●
Remove the fuel tank from the boat be-
fore cleaning it. Work only outdoors in an
area with good ventilation.
●
Wipe up any spilled fuel immediately.
●
Reassemble the fuel tank carefully. Im-
proper assembly can result in a fuel leak,
which could result in a fire or explosion
hazard.
●
Dispose of old gasoline according to lo-
cal regulations.
1. Empty the fuel tank into an approved
container.
2. Pour a small amount of suitable solvent
into the tank. Install the cap and shake the
tank. Drain the solvent completely.
3. Remove the screws holding the fuel joint
assembly. Pull the assembly out of the tank.
Tightening torque:
9 Nm (0.9 kgf-m, 6.6 ft-lb)
7. Put a new gasket on the gear oil drain
To Next Page
Loading...
Need help?
General
