measure the electrode gap with a wire
thickness gauge; replace it if out of spec-
ification.
1. Spark plug gap
2. Spark plug part number
3. Spark plug I.D. mark (NGK)
Spark plug gap:
0.8–0.9 mm (0.031–0.035 in)
4. When fitting the plug, wipe off any dirt
from the threads, and then screw it in to
the correct torque.
Spark plug torque:
F40 18.0 Nm (1.84 kgf-m, 13.3 ft-lb)
F60 18.0 Nm (1.84 kgf-m, 13.3 ft-lb)
TIP:
If a torque-wrench is not available when you
are fitting a spark plug, a good estimate of the
correct torque is 1/4 to 1/2 a turn past fin- ger-
tight. Have the spark plug adjusted to the
correct torque as soon as possible with a
torque-wrench.
Inspecting idle speed
WARNING
●
Do not touch or remove electrical parts
when starting or during operation.
●
Keep hands, hair, and clothes away
from the flywheel and other rotating parts
while the engine is running.
NOTICE
This procedure must be performed while
the outboard motor is in the water. A
flushing attachment or test tank can be
used.
If the boat is not equipped with a tachometer
for the outboard motor, use a diagnostic ta-
chometer for this procedure. Results may
vary depending on whether testing is con-
ducted with the flushing attachment, in a test
tank, or with the outboard motor in the water.
1. Start the engine and allow it to warm up
fully in neutral until it is running smoothly.
2. Once the engine has warmed up, verify
whether the idle speed is set to specifi-
cation. For idle speed specifications, see
page 12. If you have difficulty verifying the
idle speed, or the idle speed requires
adjustment, consult a Hidea dealer or other
qualified mechanic.
Changing engine oil
NOTICE
Change the engine oil after the first 20
hours of operation or 3 months, and ev-
ery 100 hours or at 1-year intervals there-
after. Otherwise the engine will wear
quickly.
To Next Page
Loading...
Need help?
General
