The engine oil should be extracted with an oil
changer.
1. Put the outboard motor in an upright po-
sition (not tilted). NOTICE: If the out- board
motor is not level, the oil level indicated
on the oil dipstick may not
be accurate.
oil level is above the upper level mark,
drain until the level meets the
specified capacity.
1. Oil filler
cap
2. Start the engine. Warm it up and keep
the idle speed for 5-10 minutes.
3. Stop the engine and leave it for 5-10
minutes.
4. Remove the top cowling.
5. Remove the oil filler cap. Pull out the dip-
stick and use the oil changer to extract the oil
completely.
1. Oil filler cap
1. Oil
changer
Recommended engine oil:
4-stroke outboard motor oil Replacement
engine oil quantity (at peri- odic
maintenance):
Without oil filter replacement:
1.9 L (2.01 US qt, 1.67 Imp.qt)
With oil filter replacement:
2.1 L (2.22 US qt, 1.85 Imp.qt)
7. Leave the outboard motor for 5-10 min-
6. Add the correct amount of oil through the
filler hole. Put back the filler cap and the
dipstick. NOTICE: Overfilling the oil could
cause leakage or damage. If the
utes.
8. Remove oil dipstick and wipe it clean.
9. Insert the dipstick and remove it again.
Be sure to completely insert the dipstick
To Next Page
Loading...
Need help?
General
