shown. NOTICE: If the top cowling is
not installed correctly, water spray
under the top cowling can damage the
engine, or the top cowling can blow off
at high speeds.
motor before performing this check.
1. Check the power trim and tilt unit for any
sign of oil leaks.
2. Operate each of the power trim and tilt
switches to check that all switches work.
3. Tilt the outboard motor up and check
that the trim and tilt rod is pushed out
completely.
After installing, check the fitting of the top
cowling by pushing it with both hands. If the
top cowling is loose, have it repaired by your
Hidea dealer.
1. Trim and tilt rod
Power trim and tilt system
●
Never get under the lower unit while it
is tilted, even when the tilt support lever is
locked. Severe injury could occur if the
outboard motor accidentally falls.
●
Body parts can be crushed between the
motor and the clamp bracket when the
motor is trimmed or tilted.
●
Be sure no one is near the outboard
4. Check that the trim and tilt rod is free of
corrosion or other flaws.
5. Tilt the outboard motor down. Check that
the trim and tilt rod operates smoothly.
Battery
Check that the battery is in good condition,
and fully charged. Check that the battery
connections are clean, secure and covered
by insulating covers. The electrical contacts
of the battery and cables must be clean and
properly connected or the battery will not
start the engine.
Refer to the battery manufacturer’s instruc-
tions for checks for your particular battery.
Filling fuel
WARNING
●
Gasoline and its vapors are highly flam-
mable and explosive. Always refuel ac-
To Next Page
Loading...
Need help?
General
