Chapter 6. Parameter Setting
6-1
6. Parameter Setting
Menus can be set by the digital loader and mount loader. See Chapter 4 and 5 for information
on how to use the digital loader and mount loader.
Abbreviations used in this manual and their meanings are as follows.
Abbreviation Meaning Abbreviation Meaning
PC Position Controller ACCEL Acceleration
SC Speed Controlller DECEL Deceleration
LMT Limit VOLT Voltage
RPM r/min SPD Speed
ms msec OFFS Offset
μs μsec TC Time Constant
FRQ Frequency FF Feedforward
FLT Filter FB Feedback
ENB Enable ERR Error
INIT Initialize FLLW Follow
DFLT Default ELCTR Electric
PROG Program NUM Numerator
CMD Command DEN Denominator
Meanings of the modes in the following parameter summary are shown below.
Mode Meaning
S Effective in speed control mode
P Effective in position control mode
T Effective in torque control mode
To Next Page
Loading...