viii
Trackspot User Manual
Additional Hardware .................................................................... 2-8
Truss or Other Support System ............................................ 2-8
Safety Cable ........................................................................... 2-9
Clamp ..................................................................................... 2-9
Obtaining Cabling and Terminators ................................................. 2-10
Constructing Cabling ................................................................. 2-11
Constructing Terminators .......................................................... 2-11
Linking the Fixtures .......................................................................... 2-12
DMX 512 Protocol ...................................................................... 2-12
LWR Protocol .............................................................................. 2-14
Standard Analog ......................................................................... 2-15
Stand Alone Operation (Master/Slave) ..................................... 2-16
Focusing the Fixture .......................................................................... 2-17
Chapter 3 General Maintenance
Replacing Parts .................................................................................... 3-1
Replacing the Lamp ...................................................................... 3-1
Replacing Power Supply Fuses ................................................... 3-4
Replacing the Mirror Assembly ................................................... 3-6
Replacing or Installing Custom Gobos ....................................... 3-7
Cleaning Your Trackspot
®
.................................................................. 3-9
Cleaning the Outer Surfaces ........................................................ 3-9
Cleaning the Internal Components ........................................... 3-10
Removing the Color Wheel or Gobo Wheel ....................... 3-10
Reinstalling the Color Wheel or Gobo Wheel .................... 3-12
Adjusting Wheel Clearance ............................................................... 3-12
Chapter 4 Troubleshooting
Fixture does not work: no LEDs, fans, lamp, or other
functionality (fixture appears dead) ................................................... 4-1
Lamp will not strike ............................................................................. 4-1
Light output is low, beam edge is very soft, images fuzzy ............... 4-1
Lamp shuts off ..................................................................................... 4-2
Error tone (two level beeping) after the fixture homes .................... 4-2
Yellow Enable LED or green Audio LED does not illuminate .......... 4-3
Fixture does not respond to data ........................................................ 4-3
Color wheel or gobo wheel is not centered in the beam or is in
the wrong position ............................................................................... 4-3
None of the motors work and the yellow Enable LED does not illuminate
4-4
Appendix A DMX Control of Trackspot
®
Start Channels and Construct Parameters ........................................A-1
Low Resolution Mode ...................................................................A-1
High Resolution Mode ..................................................................A-1
To Next Page
Loading...