HikRobot CA Series - Chapter 10 Image Parameter; 10.1 Check Resolution; 10.2 Set ROI; 10.3 Set Image Reverse

CA/CE-Series GigE Area Scan Camera·User Manual
2
1
2
3
4
5
Figure 1-4 Interface (Type I)
Table 1-1 Interface Description
No.
Description
1
Lens mount
2
6-pin power and I/O interface
3
M2 screw holes for securing network cable
4
RJ45 Gigabit Ethernet interface
5
LED indicator
The CA/CE-series GigE area scan camera has 3 kinds of appearance, and here we take type I as an
example for interface introduction.
1.2 Power and I/O Interface
The description of the 6-pin power and I/O interface is shown in Table 1-2.
Table 1-2 Pin Definition
Illustration
No.
Signal
I/O Signal Source
Description
1
2
3 4
5
6
1
DC_PWR
--
DC Power
2
Opt-Iso In
Line 0 signal line
Opto-isolated input
3
GPIO
Line 2 signal line
Can be configured as
input or output
4
Opt-Iso Out
Line 1 signal line
Opto-isolated output