CA/CE-Series GigE Area Scan Camera·User Manual
32
2. Enable Chunk Mode Active.
3. Select specific parameters in Chunk Selector according to actual demands.
4. Enable Chunk Enable.
Figure 7-22 Set Chunk Data Control
7.8 Action Commands
The Action Command is used to trigger actions in multiple cameras in a network simultaneously.
When Action Command is configured, the client can send commands across the network and have
devices in a pre-defined group respond based on how they have been configured to respond to
certain commands.
In MVS, action command is usually used for generating images in multiple cameras simultaneously,
and the generated images can be used for image fusion.
The action commands function is available only with client software version of V3.1.0 and
higher.
This function should be supported by the device, and please refer to your camera for actual
features.
Steps:
1. Click Tool > GigE Vision Action Command.
2. Select Network Interfaces to set the subnet that the command to be sent to.
3. Enter the Device Key, Group Key, and Group Mask.
To Next Page
Loading...
