CA/CE-Series GigE Area Scan Camera·User Manual
22
Figure 7-5 Set External Trigger Source
These 5 external trigger sources are valid only when the Trigger Mode is On.
7.4.2 Set Software Trigger
You can set software trigger as shown below.
Steps:
1. Click Acquisition Control > Trigger Selector.
2. Select Frame Burst Start as Trigger Selector, and On as Trigger Mode.
3. Select Software as Trigger Source, and click Execute in Trigger Software to send trigger
commands.
Figure 7-6 Set Software Trigger
7.4.3 Set Hardware Trigger
The camera has 1 Opto-isolated input (Line 0), and 1 bi-directional I/O (Line 2) that can be
configured as input signal, as shown below.
To Next Page
Loading...
