CA/CE-Series GigE Area Scan Camera·User Manual
63
Steps:
1. Click Analog Control > Gamma Selector.
2. Select User as Gamma Selector.
3. Enable Gamma Enable.
4. Enter proper value in Gamma according to actual demands, and its range is from 0 to 4.
Figure 10-22 Set User Mode
You can set sRGB mode as shown below.
Steps:
1. Click Analog Control > Gamma Selector.
2. Select sRGB as Gamma Selector.
3. Enable Gamma Enable.
Figure 10-23 Set sRGB Mode
The Gamma correction function is disabled by default.
10.14 Set Hue and Saturation
Only the color camera supports hue and saturation function.
Hue
Adjusting the hue shifts the colors of the image.
To Next Page
Loading...
