HikRobot CA Series - 10.9 Set Gain; 10.10 Set Brightness; 10.11 Set Black Level; 10.12 Set White Balance

CA/CE-Series GigE Area Scan Camera·User Manual
3
Illustration
No.
Signal
I/O Signal Source
Description
5
I/O Ground
Line 0, line 1 signal
ground
Signal ground
6
GND
Power ground and
line 2 ground
Power ground
You should refer to the table above and the label attached to the power and I/O cable to wire the
device.
1.3 Indicator Description
The indicator has different status, and please refer to the following table for the details.
Table 1-3 Indicator Description
No.
Indicator
Status
Description
1
Red indicator
It is flashing very slowly.
Network error.
2
Blue indicator
It is flashing slowly.
The camera is acquiring images in trigger
mode.
3
Blue indicator
It is flashing fast.
The camera is acquiring images normally.
4
Blue indicator
It is solid.
The camera is in idle status.
5
Red/blue
indicator
Red/blue indicator flash
alternatively.
The function of finding me is executed.
6
Red/blue
indicator
Red/blue indicator flash
alternatively.
The firmware is updating.
 When the indicator is flashing fast, flashing slowly, or flashing very slowly, its unlit interval is
0.2 s, 1 s, 2 s respectively.
 When the red and blue indicator flash alternatively, they may be unlit or flash at the same
time (purple color when indicators flash at the same).