HikRobot CA Series - File Access Control; Save and Load User Set

CA/CE-Series GigE Area Scan Camera·User Manual
71
Parameter
Read/Write
Description
Device Max
Throughput(Kbps)
Read only
It is the maximum flow of device operation.
Device PJ Number
Read only
It is the device serial number.
The specific parameters vary from device to device and are subject to the actual you got.
11.2 File Access Control
You can export the feature configuration or DPC (Defective Pixel Correction) of a connected device
to the local PC as a binary file, or import a binary file containing the feature configuration
information or DPC information from the local PC to a connected device.
 This function should be supported by the device, and it is not available if you start acquisition.
 This function is related with User Set, not the current parameters you set. Setting User Set
Save or User Set Load first if you want to link this function with the current parameters.
Steps:
1. Click to open the File Access interface.
Figure 11-1 File Access Interface
2. Select a User Set (User Set 1, User Set 2, or User Set 3) or DPC from the drop-down list.
3. Click Export to export the feature to the PC as a binary file.
11.3 Save and Load User Set
The camera supports 4 sets of parameters, including 1 default set and 3 user sets. The relation
among 4 sets of parameters is shown below.