EasyManua.ls Logo

HikRobot CA Series - Set Gain

HikRobot CA Series
94 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CA/CE-Series GigE Area Scan Camera·User Manual
58
Exposure Mode
Parameter
Parameter Value
Principle
Continuous
Acquisition Control >
Exposure Auto
Continuous
Adjust the exposure time
continuously according to
the image brightness.
When the exposure mode is set as Once or Continuous, the exposure time should be within the
range of Auto Exposure Time Lower Limit and Auto Exposure Time Upper Limit, as shown below.
Figure 10-15 Set Exposure Time under Once or Continuous Mode
If the camera is under Continuous exposure mode, once external trigger mode is enabled, the
camera will automatically switch to Off exposure mode.
10.9 Set Gain
The camera supports gain function. For specific gain range that the camera supports, please refer
to the specifications of the camera.
The camera has 3 types of gain modes: Off, Once and Continuous. The gain mode and principle are
shown below.
Table 10-3 Gain Mode and Principle
Gain Mode
Parameter
Parameter Value
Principle
Off
Analog Control >
Gain Auto
Off
The camera adjusts gain
according to the value
configured by user in Gain.
Once
Analog Control >
Gain Auto
Once
Adjust the gain
automatically according to
the image brightness. After

Table of Contents

Related product manuals