HikRobot CA Series - Page 34

CA/CE-Series GigE Area Scan Camera·User Manual
24
Figure 7-9 Set Counter Trigger
When using counter as trigger source, you need to set relevant parameters under Counter And
Timer Control. For specific parameter function and setting, please refer to the following table.
Table 7-3 Description of Counter And Timer Control
Parameter
Read/Write
Description
Counter Selector
Read and write
It selects counter source. Counter 0 is
available only at present.
Counter Event Source
Read and write
It selects the signal source of counter
trigger. Line 0 and Line 2 are available.
It is disabled by default.
Counter Reset Source
Read and write
It selects the signal source of resetting
counter. Software is available only. It
is disabled by default.
Counter Reset
Write is available
under certain
condition
It resets counter and it can be
executed when selecting Software as
Counter Reset Source.
Counter Value
Read and write
It is the counter value with the range
of 1 to 1023.
Counter Current Value
Read only
It displays the number of executed
external trigger.