HikRobot CA Series - Page 47

CA/CE-Series GigE Area Scan Camera·User Manual
37
Table 8-1 Line Source
No.
Name
Description
1
Exposure Start Active
It refers to output one I/O edge signal when starting
exposure.
2
Acquisition Start
Active
It refers to output one I/O edge signal when starting
acquisition.
3
Acquisition Stop
Active
It refers to output one I/O edge signal when stopping
acquisition.
4
Frame Burst Start
Active
It refers to output one I/O edge signal when starting
triggering and acquiring images under Burst mode.
5
Frame Burst End
Active
It refers to output one I/O edge signal when stopping
triggering and acquiring images under Burst mode.
6
Soft Trigger Out
It refers to output one I/O edge signal when software
trigger acquisition.
7
Hard Trigger Active
It refers to output one I/O edge signal when hardware
trigger acquisition.
8
Count Active
It refers to output one I/O edge signal when counter
output is enabled.
9
Timer Active
It refers to output one I/O edge signal when timer output
is enabled.
Regarding strobe signal, you can also set its duration, delay and pre delay.
 Set Strobe Line Duration
You can set strobe line duration as shown below.
Steps:
1. Click Digital IO Control > Strobe Line Duration.
2. Enter proper value in Strobe Line Duration.