Network Video Recorder User Manual
203
Step 2 Click Add to enter the operation permission interface.
Step 3 Enter the admin password and click OK.
Figure 19-5 Add User
Step 4 In the Add User interface, enter the information for new user, including User Name, Password,
Confirm (password), User Level (Operator/Guest) and User’s MAC Address.
Strong Password recommended–We highly recommend you create a strong password of your own
choosing (Using a minimum of 8 characters, including at least three of the following categories:
upper case letters, lower case letters, numbers, and special characters.) in order to increase the
security of your product. And we recommend you reset your password regularly, especially in the
high security system, resetting the password monthly or weekly can better protect your product.
User Level: Set the user level to Operator or Guest. Different user levels have different
operating permission.
Operator: The Operator user level has permission of Two-way Audio in Remote
Configuration and all operating permission in Camera Configuration by default.
Guest: The Guest user has no permission of Two-way Audio in Remote Configuration and
only has the local/remote playback in the Camera Configuration by default.
User’s MAC Address: The MAC address of the remote PC which logs onto the device. If it is
configured and enabled, it only allows the remote user with this MAC address to access the
device.
Step 5 Click OK to finish the new user account adding.
To Next Page
Loading...
Need help?
General
