Network Video Recorder User Manual
151
Figure 12-10 Sudden Scene Change
Step 4 Select a Camera to configure.
Step 5 Check Enable Sudden Scene Change Detection.
Step 6 (Optional) Check Save VCA Picture to save the captured pictures of sudden scene change
detection.
Step 7 Drag the Sensitivity slider to set the detection sensitivity. Sensitivity range: [1-100]. The
higher the value is, the more easily the change of scene can trigger the alarm.
Step 8 Set the arming schedule. Refer to Chapter 11.1 Configure Arming Schedule.
Step 9 Set the linkage actions. Refer to Chapter 11.2 Configure Alarm Linkage Actions.
Step 10 Click Apply.
12.11 Defocus Detection
Purpose:
The image blur caused by defocus of the lens can be detected.
Step 1 Go to System > Event > Smart Event.
Step 2 Select a Camera to configure.
Step 3 Click Defocus.
To Next Page
Loading...
