Network Video Recorder User Manual
153
Figure 12-12 FIR Alarm
Step 4 Select a Camera to configure.
Step 5 Check PIR Alarm.
Step 6 (Optional) Check Save VCA Picture to save the captured pictures of PIR alarm.
Step 7 Set the arming schedule. Refer to Chapter 11.1 Configure Arming Schedule.
Step 8 Set the linkage actions. Refer to Chapter 11.2 Configure Alarm Linkage Actions.
Step 9 .Click Apply.
12.13 Thermal Camera Detection
The NVR supports the event detection modes of the thermal network cameras: fire and smoke
detection, temperature detection, temperature difference detection, etc.
Before you start
Add the thermal network camera to your device and make sure the camera is activated.
Step 1 Go to System > Event > Smart Event.
Step 2 Select a thermal camera from the camera list.
Step 3 (Optional) Check Save VCA Picture to save the captured pictures of detection.
Step 4 Click an event detection (Temperature A, Temperature, etc.).
Step 5 Set the arming schedule. Refer to Chapter 11.1 Configure Arming Schedule.
To Next Page
Loading...
