HIKVISION DS-19S08N-04F/K Series

Video Security Control Panel User Manual
--24--
Working Status
Indicator Status
Working Status
Indicator Status
System Ready
Green (Continuously
Light)
LCD Partition Keypad Indicator
LCD Partition Keypad Arming/Disarming Status
Working Status
Indicator Status
Working Status
Indicator Status
In Programming
Green (Flickering)
Parameters Initialization
Green (Flickering)
Re-searching
Green (Flickering)
Re-registration
Green (Flickering)
Enable Partition
Arming
Red (Continuously Light
Enable Partition
Disarming
Green (Continuously
Light)
Partition Not Enabled
Extinguishing
LCD Partition Keypad Working Status
Working Status
Indicator Status
Working Status
Indicator Status
In Programming
Green (Flickering)
Parameters Initialization
Green (Flickering)
Re-searching
Green (Flickering)
Re-registration
Green (Flickering)
System Fault
Green (Flickering)
System Works Properly
Green (Continuously
Light)
Keypad Not Enabled
Extinguishing
Keypad Address 2.3.3
A unique address is required for each alarm keypad in the system. Once exchanging the alarm keypad, the address
of the new keypad must be the same as the replaced one. You should configure the address via DIP switch of the
keypad before powering on the system. The address should be in the range of 0~7.