Video Security Control Panel User Manual
Local Port Number Settings 3.1.10
The programming commands of local port number setting are as below:
474 0 8 0 0 0 #
1 2
4
63 5
7
{1} The programming command address of local port number setting is: 474;
{2} Port: Ten Thousands’ Digit
{3} Port: Thousands’ Digit
{4} Port: Hundreds’ Digit
{5} Port: Tens’ Digit
{6} Port: Digit
{7} End the command.
Corresponding port number must be 5 bytes. When the place is not sufficient, fill it up with 0.
For example: When the port number is 6000, the programming command is: 474 06000#.
Sub-net Mask Settings 3.1.11
The programming commands of control panel sub-net mask setting are as below:
475 255 255 255 000 #
1
2 4 63 5
{1} The programming command address of control panel sub-net mask setting is 475;
{2} The First Unit;
{3} The Second Unit;
{4} The Third Unit;
{5} The Fourth Unit;
{6} End the command.
To Next Page
Loading...
Need help?
General
