HIKVISION DS-19S08N-04F/K Series

Video Security Control Panel User Manual
--45--
Alarm Message Settings 3.1.17
The programming commands of print setting of alarm message are as below:
500 0 0 0 #
1
2 3
4
5
{1} The programming command address of alarm message printing is: 500.
{2} Enable/disable the sensor alarm;
Command
Description
Command
Description
0
Disable Sensor Alarm
1
Enable Sensor Alarm
{3} Enable/disable emergency alarm;
Command
Description
Command
Description
0
Disable Emergency Alarm
1
Enable Emergency Alarm
{4} Enable/disable duress alarm;
Command
Description
Command
Description
0
Disable Control Panel
Duress Alarm
1
Enable Duress Alarm
{5} End the command.
Device Information Settings 3.1.18
The programming commands of print setting of device information are as below:
501 0 0 0 0 0 0 0 0 #
1 2
4
63
5
7
9
8
10
{1} The programming command address of device information printing is: 501.
{2} AC Power Off;
{3} The storage battery is under voltage;
{4} Reserved, enter 0;
{5} Test Report;