Video Security Control Panel User Manual
{6} Tamper-proof of the Control Panel;
{7} The 485 device is off-line;
{8} Network error;
{9} GPRS exception.
It indicates disabled status when 2) ~9) are set to be 0, and indicates enabled status when 2) ~9) are set to be 1.
{10} End of the command.
Operation Programming Information Settings 3.1.19
The programming commands of print setting of operation programming information are as below:
502 0 0 0 0 0 0 0 #
1 2 4 63 5 7 98
{1} The programming command address of print setting of operation programming information is: 502;
{2} Arming;
{3} Disarming;
{4} Canceling the alarm;
{5} Bypass;
{6} Enter the programming;
{7} Exit the programming;
{8} Control Panel Restoring;
It indicates disabled status when 2) ~8) are set to be 0, and indicates enabled status when 2) ~8) are set to be 1.
{9} End the command.
Restoring Information of Alarm and Bypass Settings 3.1.20
The programming commands of print setting of restoring information of alarm and bypass are as below:
To Next Page
Loading...
