Video Security Control Panel User Manual
Chapter 3 Keypad Operation (Local
Operation）
3.1 Alarm Keypad Settings
You should access the programming mode (only installer can access the programming mode) before keypad
configuration. The command is shown below:
{1} Installer Password: 012345
{2} Command Key: *0 #
The command for exiting programming mode is *#.
Installer Password Settings 3.1.1
The password of installer is used for accessing programming and initializing mode. The command is shown below.
{1} Installer Password Programming Address: 000.
{2} Installer Password: The default password is 012345. The configured password cannot be NULL,
but can be 0.
{3} End the command.
To Next Page
Loading...
