HIKVISION DS-2XS6A87G1-LS/4G - Page 70

Capture Baseband Packet
This funcon can capture the protocol interacon packet to help the professionals to locate the
communicaon failures between 4G module and the base staon.
Steps
Note
This funcon is reserved for the professionals and technical support sta.
1.
Go to Conguraon → Network → Basic Sengs → Wireless Expert Sengs → Advanced
Sengs → Maintenance .
2.
Click Capture Baseband Packet to enter the seng interface.
3.
Check Capture Baseband Packet.
4.
Set capture
duraon and the saving path. The saving path depends on the actual storage
method of the device. You can click Delete Captured Packet Under This Path to delete the
captured packet.
5.
Click Save.
6.
Click Start Capture to capture the baseband packet.
7.
Oponal: Click Stop Capture to stop the capturing process.
8.
Click Export Report.
9.
Click OK to exit the interface.
Speed Test
Steps
1.
Go to Conguraon → Network → Basic Sengs → Wireless Expert Sengs → Advanced
Sengs → Maintenance .
2.
Click Speed Test to enter the seng interface.
3.
Select the default server or enter the server address. You can follow the steps below to get the
nearby server address.
Note
You can follow the steps below to get the nearby server address.
a. Visit this website to get the nearby server address: hps://www.speedtest.net/speedtest-
servers-stac.php .
b. Select and copy the URL of the nearby speed test
staon and paste it in Server Address.
4.
Click Speed Test to start the test.
You can view the speed details
aer the test is completed. You can also click Export Report.
Network Camera User Manual
58