HIKVISION DS-2XS6A87G1-LS/4G - Power Output Mode; Location Settings

9.16 Power Output Mode
Set the external power supply method for 12 VDC power output of the device.
Go to Conguraon → System → System Sengs → External Device and set the Power Output
Mode.
Power Saving
The device can supply power to the external device through the power output interface only
when the device performs two-way audio or audio output, or triggers the audio output and
alarm output linkage method. At other
mes, the device does not supply power to the external
device through the power output interface.
NO
Normally Open.
NC
Normally Close.
9.17
Locaon Sengs
Locaon displays and uploads the current longitude and latude of the device.
Auto Uploading
Check Enable and set
Locaon Upload Interval.
The device will upload its locaon at the set interval. You can also click Refresh to upgrade the
device
locaon manually.
Figure 9-1 Auto Uploading
Manual Sengs
Check Enable and set Locaon Upload Interval. Enter the longitude and latude of the device
and click Save.
The device will upload the set
locaon at the set interval.
Network Camera User Manual
79