Access Control Terminal·User Manual
81
7. Click Add at the bottom to add the configured the authentication group to the group list. And click Save to save the
configuration.
Note:
Click Apply on the upper-left to take effect of the new settings.
First Card
Purpose:
The door remains open for the configured time duration after the first card swiping.
Steps:
1. Click First Card and select an access control point.
2. Check the checkbox of Enable First Card Remain Open to enable this function.
3. In the Remain Open Duration (min), input the time duration for remaining open the door.
4. Click Add and select the cards to add as first card for the door and click the OK button.
5. Click Save and then click the Apply button to take effect of the new settings.
Anti-Passing Back
Purpose:
In this mode, you can only pass the access control system according to the specified path.
Note: Either the anti-passing back or multi-door interlocking can be configured for an access controller at the same time.
Setting the Path of Swiping Card (Card Reader Order)
Steps:
1. Click Anti-passing Back and select an access control point.
To Next Page
Loading...
Need help?
General
