HIKVISION DS-K1T321 Series User Manual

Note
●
Make sure your face picture is in the face picture outline when adding the face picture.
●
Make sure the captured face picture is in good quality and is accurate.
●
For details about the instrucons of adding face pictures, see Tips When Collecng/
Comparing Face Picture .
Aer completely adding the face picture, a captured face picture will be displayed at the center
of the page.
7.
Press OK to save the face picture.
8.
Oponal: Press ESC to select Retake and adjust your face posion to add the face picture again.
9.
Set the user role.
Administrator
The user is the administrator. Except for the normal
aendance funcon, the user can also
enter the Home page to operate aer authencang the permission.
Normal User
The User is the normal user. The user can only authencate or take aendance on the inial
page.
10.
Press ESC and then press OK to save the
sengs.
7.3.3 Add Fingerprint
Add a ngerprint for the user and the user can authencate via the added ngerprint.
Steps
Note
●
The funcon should be supported by the device.
●
Up to 1000 ngerprints can be added.
1.
Long press OK and login the device.
2.
Press User → Add User to enter the Add User page.
3.
Select the Employee ID
eld and edit the employee ID.
Note
●
The employee ID should be less than 32 characters. And it can be a combinaon of lower
leers, upper leers, and numbers.
●
The employee ID should not start with 0 and should not be duplicated.
4.
Select the Name eld and input the user name on the keyboard.
DS-K1T321 Series Face Recognion Terminal User Manual
32

HIKVISION DS-K1T321 Series Specifications

General

Brand	HIKVISION
Model	DS-K1T321 Series
Category	Touch terminals
Language	English