HIKVISION DS-K1T321 Series User Manual

If you choose V5.0, you should create an account and ISUP key. If you choose other version,
you should create an ISUP account only.
Note
●
Remember the ISUP account and ISUP key. You should enter the account name or the key
when the device should communicate with other plaorms via ISUP protocol.
●
ISUP key range: 8 to 16 characters.
7.2.4 Plaorm Access
You can change the device vericaon code and set the server address before you add the device
to the Hik-Connect mobile client.
Before You Start
Make sure your device has connected to a network.
Steps
1.
Select System
Sengs → Comm. (Communicaon) on the Home page to enter the
Communicaon sengs page.
2.
On the
Communicaon sengs page, select Hik-Connect.
3.
Enable Hik-Connect
4.
Enter Server IP.
5.
Create the
Vericaon Code, and you need to enter the vericaon code when you manage the
devices via Hik-Connect.
6.
Select Device QR Code, scan the QR code to bind the device.
7.2.5 Set RS-485 Parameters
The face recognion terminal can connect external access controller, secure door control unit, or
card reader via the RS-485 terminal.
Steps
1.
Select System Sengs → Comm. (Communicaon Sengs) on the Home page to enter the
Communicaon Sengs page.
2.
On the Communicaon Sengs page, select RS-485 to enter the RS-485 tab.
3.
Select an peripheral type according to your actual needs.
Note
If you select Access Controller: If connect the device to a terminal via the RS-485 interface, set
the RS-485 address as 2. If you connect the device to a controller, set the RS-485 address
according to the door No.
4.
Select ESC and you should reboot the device if you change the parameters.
DS-K1T321 Series Face Recognion Terminal User Manual
28

HIKVISION DS-K1T321 Series Specifications

General

Brand	HIKVISION
Model	DS-K1T321 Series
Category	Touch terminals
Language	English