HIKVISION DS-K1T321 Series User Manual

Select an authencaon mode according to your actual needs from the drop-down list.
Connuous Face Recognion Interval (s)
You can set the interval between 2 connuous recognion of a same person during the
authencaon. In the congured interval, Person A can only recognized once. If another
person (Person B) has recognized during the interval, Person A can recognized again.
Authencaon Interval
You can set the authencaon interval of the same person when authencang. The same
person can only
authencate once in the congured interval. A second authencaon will be
failed.
Alarm of Max. Failed Aempts
Enable to report alarm when the card reading aempts reach the set value.
Main Interface Mode
You can set the Main Interface Mode as Authencaon Mode or Simple.
Communicaon with Controller Every
When the access control device cannot connect with the card reader for longer than the set
me, the card reader will turn oine automacally.
Max. Interval When Entering Password
When you entering the password on the card reader, if the interval between pressing two
digits is longer than the set value, the digits you pressed before will be cleared
automacally.
OK LED Polarity/Error LED Polarity
Set OK LED Polarity/Error LED Polarity of the access control device according to the card
reader parameters. Generally, adopts the default sengs.
Enable Tampering Detecon
Enable the an-tamper detecon for the card reader.
Enable Card No. Reversing
The card No. will be in reverse sequence aer enabling the funcon.
Set Door Parameters
Tap → Access Control → Door Parameters .
DS-K1T321 Series Face Recognion Terminal User Manual
66

HIKVISION DS-K1T321 Series Specifications

General

Brand	HIKVISION
Model	DS-K1T321 Series
Category	Touch terminals
Language	English