HIKVISION DS-K1T321 Series User Manual

Enable M1 card and authencang by presenng M1 card is available.
M1 Card Encrypon
M1 card encrypon can improve the security level of authencaon.
Sector
Enable the
funcon and set the encrypon sector. By default, Sector 13 is encrypted. It is
recommended to encrypt sector 13.
Enable EM Card
Enable EM card and authencang by presenng EM card is available.
Note
EM card is supported when the device connects a peripheral card reader that supports
presenng EM card.
Enable DESFire Card
The device can read the data from DESFire card when enabling the DESFire card funcon.
Enable FeliCa Card
The device can read the data from FeliCa card when enabling the FeliCa card funcon.
Set RS-485 Parameters
You can set the RS-485 parameters including the peripheral, address, baud rate, etc.
Tap → Access Control → RS-485 .
Tap Save to save the sengs aer the conguraon.
Peripheral Type
Select a peripheral from the drop-down list according the actual situaon. You can select from
Card Reader, Extension Module, or Access Controller.
Note
Aer the peripheral is changed and saved, the device will reboot automacally.
RS-485 Protocol
Private
The device can connect with the third party device via RS-485.
OSDP
Standard RS-485 protocol.
RS-485 Address
Set the RS-485 Address according to your actual needs.
DS-K1T321 Series Face Recognion Terminal User Manual
69

HIKVISION DS-K1T321 Series Specifications

General

Brand	HIKVISION
Model	DS-K1T321 Series
Category	Touch terminals
Language	English