NVR User Manual 061220NA 27
Setup Wizard at that moment, click the Cancel button. You can also choose to use the Setup Wizard
next time by leaving the “Start wizard when the device starts?” checkbox checked.
2. Click the Next button to enter the date and time settings window, as shown below.
Figure 21, Date and Time Settings
3. After the time settings, click the Next button, which takes you back to the Network Setup Wizard
window, as shown below.
Figure 22, Network Settings
4. Click the Next button after you configure the basic network parameters. Enter the Hik-Connect
interface to configure the parameters. See
Configuring Hik-Connect
for detailed instructions.
To Next Page
Loading...
