NVR User Manual 061220NA 15
2. Type a number (255 digits maximum) into the Device No. field.
3. On the IR Remote:
4. Press the DEV button.
5. Use the Number buttons to enter the Device ID# that was entered into the NVR.
6. Press Enter button to accept the new Device ID#.
Figure 2, Remote Control
1.2.2 Unpairing (Disabling) an IR Remote from an NVR
To unpair an IR Remote from a NVR so that the unit cannot control any NVR functions, proceed as follows:
Press the DEV key on the IR Remote. Any existing Device ID# will be erased from the unit’s memory and it
will no longer function with the NVR.
NOTE: (Re)-enabling the IR Remote requires pairing to a NVR. See “Pairing the IR Remote to a
Specific NVR (optional),” above.
The keys on the remote control closely resemble the ones on the front panel.
To Next Page
Loading...
