NVR User Manual 061220NA 70
5.8 Configuring Redundant Recording
Purpose
Enabling redundant recording, which means saving the record files and captured pictures not only in the
R/W HDD, but also in the redundant HDD, to effectively enhance the data safety and reliability.
1. Enter the HDD Information interface, Menu > HDD.
Figure 90, HDD General
2. Select the HDD and click to enter the Local HDD Settings interface.
1) Set the HDD property to Redundancy.
Figure 91, HDD General−Editing
2) Click Apply to save the settings.
3) Click OK to go back to the upper level menu.
NOTE: You must set the Storage mode in the HDD advanced settings to Group before you set
the HDD property to Redundant. For detailed information, refer to
Setting HDD Property
.
There should be at least another HDD that is in Read/Write status.
3. Enter the Record setting interface, Menu > Record > Parameters.
1) Select Record tab.
2) Click More Settings to enter the following interface.
To Next Page
Loading...
