NVR User Manual 061220NA 39
Up to four network cameras can be connected to /4P models, eight network cameras to /8P models, and 16
network cameras to /16P models. If you disable the PoE interface, you can also connect to online network
cameras. Also, the PoE interface supports the Plug-and-Play function.
Example: For DS-7608NI-I2/8P, if you want to connect six network cameras via PoE interfaces and
two online cameras, you must disable two PoE interfaces in the Edit IP Camera menu.
To Add Cameras for NVR Supporting PoE Function
Before You Start
Connect the network cameras via the PoE interfaces.
1. Enter the Camera Management interface, Menu > Camera > IP Camera
Figure 41, List of Connected Cameras
NOTE: The cameras connecting to the PoE interface cannot be deleted in this menu.
2. Click the button, and select Adding Method in the drop-down list.
• Plug-and-Play: Camera is connected to the PoE interface, so in this case, the camera parameters
can’t be edited. The IP address of the camera can be edited only in the Network Configuration
interface, see
Configuring General
Settings for detailed information.
To Next Page
Loading...
Need help?
General
