4.4 Lens
Chapter 4: Removal, Replacement, and Adjustment Procedures
Page 4 - 12 Prima™ Procedural Light Service Manual (man247ra)
DRAFT 6/4/99
Replacement
CAUTION:
Do not touch the lamp, the lens, or the inner surface of the reflector
directly. Body oils may significantly lower the life expectancy of these
parts and cause equipment damage.
1. Using a clean, dry cloth, install the lens (K) and the reflector (J) into the
clips (F).
2. Install the clamping ring (H) on the lens subassembly (E).
3. Install the lens subassembly (E) into the lamp head (B).
4. Rotate the lens subassembly (E) within the lamp head (B) to align the clips
(F) with the spacers (G).
5. Using a screwdriver, install the screws (C) and lockwashers (D) into the
into the lamp head (B).
6. Install the rear housing cover (A) onto the lamp head (B).
WARNING:
After completing a repair of the Prima™ Procedural Light, make sure
the unit is in proper operating condition. Failure to do so could result in
personal injury or equipment damage.
WARNING:
Operate the Prima™ Procedural Light only with the lens assembly in
place. Failure to do so could result in personal injury.
7. After completing a repair of the Prima™ Procedural Light, perform the
preventive maintenance checks to make sure the unit is in proper operating
condition. See “Preventive Maintenance Schedule” on page 6-7.
To Next Page
Loading...
Need help?
General
