Hill-Rom Prima Procedural Light - Lubrication Requirements

Lubrication Requirements
Chapter 6: General Procedures
Prima™ Procedural Light Service Manual (man247ra) Page 6 - 5
6
Lubrication Requirements
WARNING:
Follow the product manufacturer’s instructions. Failure to do so could
result in personal injury or equipment damage.
CAUTION:
Do not use silicone-based lubricants. Equipment damage could occur.
Hill-Rom lubricates all joint and bearing surfaces on the Prima™ Procedural
Light before each unit leaves the factory. If lubrication is required, use the
following lubricant:
P/N SA0646 Teflon®
1
spray lubricant (dry aerosol spray can). Use anywhere
light needs lubrication.
1. Teflon® is a registered trademark of E. I. du Pont and de Nemours and Company.